Issue34

Y. Li et alii, Frattura ed Integrità Strutturale, 34 (2015) 599-607; DOI: 10.3221/IGF-ESIS.34.66 603 When the matrix suction is zero, the soil pressure formula is expressed as a saturated state. In the unsaturated soil, the matrix suction can decrease the horizontal stress, and even with a negative matrix suction it will form tension stress. When tensile stress is greater than the ultimate strength of soil, cracks will appear on the surface. The maximum tensile strength of soil is f  , criterion condition as follows:       a w x a z a f u u E μ σ u σ u σ 1 u H 1 u          (10) At the initial stages of fracture, without considering a u , we can assume 0 z a u    , 0 a w u u S   , 0 S is matric suction:     a w f u u E σ H 1 u    (11) Before cracking matric suction is as follows:     f f 0 a w σ H 1 μ S u u E     (12) In the isotropic linear elastic soil,   / 1 2 E H    , by the following formula:     f f 0 σ 1 μ S 1 2μ    (13) The critical condition of soil crack:     f f 0 0 σ 1 μ S S 1 2μ     (14) R ESULTS The relationship between shear strength and wet-dry cycle (1) The relationship between the number of dry-wet cycles and cohesive force is shown in Tab. 4 and Fig. 1. The cohesive force of samples 1 and 2 have essentially the same tendency for chang, and with the increase of the number of dry-wet cycles the cohesive force would decrease. After the first wet-dry cycle, the maximum cohesion of samples 1 and 2 are 39.38kPa and 38.57kPa, respectively. Sample size has no effect on the trend of the cohesion of red clay, but the method of humidification has a significant impact on cohesion, meaning that after five wet-dry cycles, the cohesion of sample 3 decreases. (2) The relationship between the number of dry-wet cycles and internal friction angle is shown in Tab. 4 and Fig. 2. The internal friction angle and cohesion of samples 1 and 2 have essentially the same tendency for chang, but the internal friction angle of sample 2 is generally greater than that of sample 1, so sample size has significant effects on the internal friction angle. After two dry-wet cycles, the internal friction angle of sample 3 drops little, but after the third wet-dry cycle, the internal friction angle drops rapidly, the minimum value being 6.68 ° , so vacuum saturation has greater effect on the internal friction angle of samples than artificial humidification. The relationship between shear strength and crack ratio (1) The relationship between cohesive force and crack ratio is shown in Tab. 5 and Fig. 3. With crack ratio increasing the cohesive force of samples would decrease, but the reducing tendency shows little difference. When the crack