Issue 32

N. Golinelli et alii, Frattura ed Integrità Strutturale, 32 (2015) 13-23; DOI: 10.3221/IGF-ESIS.32.02 14 gas. The accumulator is used to compensate the volume change due to the piston rod moving inward the cylinder. To eliminate the floating piston, emulsified oil may be used, distributing the expansion and rod-accommodation volume throughout the main oil volume. The gas separates, but quickly re-emulsifies on action. The valves must be rated to allow for the passage of emulsion rather than liquid oil. Mineral damper oil has long chain hydrocarbon molecules which do not pack efficiently together. This allows a higher compressibility than a liquid such as water because the long molecular chains can distort. In the double-tube type of telescopic (Fig. 1b), a pair of concentric cylinder is used. The external one contains some gas to accommodate the rod displacement volume. The through-rod telescopic (Fig. 1c) avoids the displacement volume issue by having a passing-through rod which causes no volume variation. However this has several disadvantages; there are external seals at both ends subject to high pressures that causes additional friction, the protruding free end may be inconvenient or dangerous, and there is still no provision for thermal expansion of the oil. However it is a simple solution which is used for example in some seismic application. Even though this architecture has proved impractical for suspension damping, it is sometimes used for damping of the steering. (a) (b) (c) Figure 1 : Telescopic architectures. Single-tube (a) , double-tube (b) and through-rod (c) . M ATERIALS AND METHODS ince the active control of the pressure is needed, no flexible diaphragms or compressible gases are allowed. This is because flexible parts would absorb the change in pressure. Hence, it is necessary an architecture without volume compensation. Fig. 2 shows the conceptual scheme of the damper presented in this paper. We used a bottom-rod fixed to the end plug and coupled with the piston head. The bottom-rod has the same diameter of the upper-rod so that there is no volume variation. During piston movement, the bottom-rod is moving inward the chamber obtained into the piston head. The chamber is also directly connected to the canal through the upper-rod in order to bring out the coil’s wire. Thereby, overpressure or depression within the chamber will not occur. It is worth noting that two coils were adopted. In this way, the longer axial length of the piston head is exploited to maximize the concatenated magnetic flux. The main dimensions of the damper are shown in Tab. 1. Cylinder length, (mm) 192 Cylinder diameter, (mm) 50 Rod diameter, (mm) 20 Figure 2 : Conceptual scheme of the MR damper. Table 1 : Main system dimensions. S