numero25

P. Lazzarin et alii, Frattura ed Integrità Strutturale, 25 (2013) 61-68 ; DOI: 10.3221/IGF-ESIS.25.10 65 -300 -200 -100 0 100 200 300 -140 -100 -60 -20 20 60 100 140 Shear stress components [MPa]  [°]  z   zr x y r  Solid Lines: Eqs. (9) Symbols: FEM  100 MPa  100 MPa Figure 3 : Plots of the stress components  z  and  zr along a circular path of radius r = 0.001 mm centred at the notch tip,  135° ≤  ≤135°, and comparison with Eq. (9). Rectangular hole in a thick plate under tension. Distance from the mid plane z=2.5 mm. Nominal stress  n =100 MPa. The stresses have been evaluated initially along the notch bisector line, with reference to the distance z=2.5 mm from the mid-plane. Results are shown in figure 2 where that the singularity degree of in-plane stresses is shown to be in agreement with the Williams solution. It is worth noting that the stress components   , linked to the local mode I, is much higher than the mode III stress component  z   Antiplane shear stresses from FEA have been evaluated also on a circular path of radius r=0.001 mm centred at the notch tip and compared to the theoretical prediction based on Eq. (9). The comparison, shown in figure 3, documents a satisfactory agreement. Figure 4 shows the through the thickness variation of the NSIFs, K 1 , K 2 , K 3 . It can be seen that the hypothesis postulated in the previous section are verified on the major part of the plate thickness: the in-plane NSIFs are almost constant while K 3 varies linearly with z up to a maximum value which is located in the vicinity of the free surface. 0 10 20 30 40 50 60 70 0 100 200 300 400 500 600 0 0.5 1 1.5 2 2.5 3 K 3 [MPa mm 0.3333 ] K 1 [MPa mm 0.456 ], K 2 [MPa mm  ] Distance from mid plane [mm] K 1 K 2 K 3 Rectangular hole Tension loadings Figure 4 . NSIFs plotted along the thickness of the plate. Rectangular hole in a thick plate under tension. Nominal stress  =100 MPa. 3D V- NOTCHED PLATE UNDER TORSION LOADING n this session another example of coupled mode generation is discussed. A finite thickness plate weakened by a crack has been modeled and two forces have been applied to generate Mode III loading on the plate (see Fig. 5). The values of the stress intensity factors, tied to the generating and the coupled mode and normalized by K III, appl. , defined I