Issue 2

Al. Carpinteri et al., Frattura ed Integrità Strutturale, 2 (2007) 10-16; DOI: 10.3221/IGF-ESIS.02.02 10 1 INTRODUCTION Fatigue crack growth data for ductile materials are usu- ally presented in terms of the crack growth rate, d a /d N , and the stress-intensity factor range, ( ) max min K K K Δ = − . At present, it is a common practice to describe the proc- ess of fatigue crack growth by a logarithmic d / d a N vs. K Δ diagram (see e.g. Fig. 1) . Three regions are generally recognized on this diagram for a wide collection of experimental results [1] . The first region corresponds to stress-intensity factor ranges near a lower threshold value, th K Δ , below which no crack propagation takes place. This region of the diagram is usually referred to as Region I , or the near-threshold re- gion [2] . The second linear portion of the diagram defines a power-law relationship between the crack growth rate and the stress-intensity factor range and is usually re- ferred to as Region II [3] . Finally, when max K tends to the critical stress-intensity factor, IC K , rapid crack propagation takes place and crack growth instability oc- curs ( Region III ) [4]. In Region II the Paris’ equation [5,6] provides a good approximation to the majority of experimental data: d ( ) d m a C K N = Δ (1) where C and m are empirical constants usually referred to as Paris’ law parameters. From the early 60’s, research studies have been focused on the nature of the Paris’ law parameters, demonstrating that C and m cannot be considered as material constants. In fact, they depend on the testing conditions, such as the loading ratio min max min max / / R K K σ σ = = [7] , on the ge- ometry and size of the specimen [8, 9] and, as pointed out very recently, on the initial crack length [10] . However, an important question regarding the Paris’ law parameters still remains to be answered: are C and m independent of each other or is it possible to find a correlation between them based on theoretical considerations? Concerning this point, it is important to take note of the controversy in the literature about the existence of a correlation be- tween C and m . For instance, Cortie [11] stated that the correlation is formal with a little physical relevance, and the high coefficient of correlation between C and m is due to the logarithmic data representation. Similar argu- ments were proposed in [12], where a correlation-free representation was presented. On the other hand, a very consistent empirical relationship between the Paris’ law parameters was found by several Authors [13, 14] and supported by experimental results [3, 13, 15–18] . In this paper, the correlation existing between the Paris’ law parameters is derived on the basis of theoretical ar- guments. To this aim, both self-similarity concepts [9] and the condition that the Paris’ law instability corre- sponds to the Griffith-Irwin instability at the onset of rapid crack growth are profitably used. Comparing the functional expressions derived according to these two in- Are the Paris’ law parameters dependent on each other? Alberto Carpinteri, Marco Paggi Politecnico di Torino, Dipartimento di Ingegneria Strutturale e Geotecnica, Corso Duca degli Abruzzi 24, 10129 Torino, Italy RIASSUNTO. Nel presente articolo si riesamina la questione relativa all’esistenza di una correlazione tra i parametri C ed m della legge di Paris. In base all’analisi dimensionale ed ai concetti di autosomiglianza in- completa applicati alla fase lineare della propagazione della frattura per fatica, si propone una rappresenta- zione asintotica che mette in relazione il parametro C ad m ed alle altre variabili che governano il fenomeno in oggetto. Gli esponenti della correlazione vengono poi determinati in base alla condizione che l’instabilità alla Griffith-Irwin debba coincidere con l’instabilità alla Paris nel punto di transizione tra la propagazione sub-critica e quella critica. Si riscontra infine un ottimo accordo tra la correlazione proposta e l’evidenza sperimentale relativamente alle leghe di alluminio, titanio ed acciaio. ABSTRACT . The question about the existence of a correlation between the parameters C and m of the Paris’ law is re-examined in this paper. According to dimensional analysis and incomplete self-similarity concepts applied to the linear range of fatigue crack growth, a power-law asymptotic representation relating the parameter C to m and to the governing variables of the fatigue phenomenon is derived. Then, from the observation that the Griffith-Irwin instability must coincide with the Paris’ instability at the onset of rapid crack growth, the exponents entering this correlation are determined. A fair good agreement is found be- tween the proposed correlation and the experimental data concerning Aluminium, Titanium and steel alloys. KEYWORDS. Fatigue crack growth, Paris’ law parameters, Correlation, Dimensional analysis, Griffith- Irwin instability.