Issue 13

F. Iacoviello et alii, Frattura ed Integrità Strutturale, 13 (2010) 3-16 ; DOI: 10.3221/IGF-ESIS.13.01 6 Figure 6 : Ferritic-pearlitic DCI (obtained by means of a pearlitic DCI annealing). 50% ferrite – 50% pearlite. Figure 7 : Austempered DCI GGG 70BA (ADI). Fatigue crack propagation tests were performed in laboratory conditions according to ASTM E647 standard [22], using 10 mm thick CT (Compact Type) specimens and considering three different stress ratio values (e.g. R=P min /P max = 0.1; 0.5; 0.75). Tests were performed using a computer controlled servohydraulic machine in constant load amplitude conditions, considering a 20 Hz loading frequency, a sinusoidal loading waveform. Crack length measurements were performed by means of a compliance method using a double cantilever mouth gage and controlled using an optical microscope (x40). In order to investigate the fatigue crack propagation micromechanisms, different procedures were applied: - Scanning electron microscope (SEM) observations of the crack path during fatigue crack propagation test (cracks propagate from left to right); - “Traditional” SEM fracture surface analysis (cracks propagate from left to right); - 3D fracture surface reconstruction performed after SEM analysis; - Light optical microscope (LOM) transversal crack paths analysis. These experimental procedures were not applied to all the investigated DCI. 3D fracture surface reconstruction procedure was performed in order to perform a quantitative analysis of the microstructure influence on the graphite elements debonding morpholog y [14]. Corresponding to the same specimen position, a stereoscopic image was obtained performing an eucentric tilting around the vertical axis and capturing two different images (Fig. 8), with a tilting angle equal to 5°. A 3D surface reconstruction was performed by means of Alicona MeX software, obtaining images as in Fig. 9. 3D quantitative reconstruction allowed to investigate fracture surface profiles, as reported i n Fig. 10. Figure 8 : Two SEM images obtained by means of an eucentric tilting around the vertical. Figure 9 : 3D reconstructed fracture surface (50% ferrite – 50% pearlite). At least 50 voids were considered for all the investigated ductile irons and fracture surface profiles were quantitatively analyzed. Each void was characterized considering an approximation sphere (the “lost” graphite nodule) and three different geometrical parameters were considered: