General Papers
| A probabilistic model for cleavage fracture of polycrystalline metals containing a dispersion of brittle particles | |
| A.M. MEIZOSO, R. G. ARRIZABALAGE, J. G. SEVILLANO |
| The crack-inclusion interaction problem in an infinite strip | |
| O.S. YAUSI, S. ABBAS |
| Stress analysis by F.E.M. in crack tip and free edge regions in composite material structural elements | |
| A. MANUELLO BERTETTO, G. AUGELLO |
| Effect of tempering treatment on fracture toughness of 0.4 C steel | |
| B. ERYUREK, E. AKATA |
| The effect of heat-affected-zone microstructures on fracture toughness of duplex stainless steels | |
| S. ATAMERT, J.E. KING |
| Investigation of sulfide stress corrosion cracking in low alloy steels | |
| V.I. ASTAFJEV, V.K. EMELIN, T.V. TETJUEVA |
| The effects of a sulphur-containing environment on high temperature fatigue failure of a nickel based superalloy | |
| E.E. AGHION |
| Fatigue crack propagation in alumina under cyclic compressive loads | |
| J.M. SABADELL, M. ANGLADA |
| Mixed mode fracture in compact shear specimens | |
| A. ARSLAN, T.G. HUGHES, B.I.G. BARR |
| Crack ratio and spall off ratio of reinforced concrete columns | |
| J. OGAWA, M. HOSHI, Y. ABE |
| Dynamic properties of high strength metallic materials | |
| M.M. AL-MOUSAWI |
| The transition from plastic flow to combined flow and fracture: the scaling of JR curves | |
| A.G. ATKINS |
| On non-linear effects in edge-cracked tension specimens | |
| M.A. ASTIZ, C. NAVARRO |
| Minimum critical length of a microcrack as a construction material criterion | |
| Y. I. RAGOZIN, Y. Y. ANTONOV |
| Influence of time dependent mechanisms on fatigue crack growth in a single crystal nickel-base superalloy | |
| G. ONOFRIO, S.H. AI, V. LUPINC, G. VIMERCATI |
| Effect of stress ratio and maximum stress on crack closure | |
| K. ANANDAN, P.K. DASH, K.K. BRAHMA |
| The effect of solution pH on the initiation and growth of short fatigue cracks | |
| R. AKID, k.J. MILLER |
| An overview of the NDE flaw acceptance standards based on the R6 assessment | |
| A. ALICINO, E. CAPURRO, A. CORVI, P. PIOVANELLI, S. REALE |
| Comparison of J Integral behaviour for the tensile panel and pressure vessel | |
| T. ADZIEV, S. SEDMAK, J. GOCEV |
| Application of probabilistic fracture mechanics theory to calculation of life of gears | |
| B. ABERSEK, S. MIKLUS, J. FLASKER, M. LAKOTA |
| Determination of the service life of gears with cracks Initiated in tooth root | |
| J. FLASKER, S. PEHAN, B. ABERSEK |