Presentations and Authors


Last name A B C D E F G H I J K L M N O P Q R S T U V W X Y Z All
Track:
 

General Papers

A probabilistic model for cleavage fracture of polycrystalline metals containing a dispersion of brittle particles PDF
A.M. MEIZOSO, R. G. ARRIZABALAGE, J. G. SEVILLANO
The crack-inclusion interaction problem in an infinite strip PDF
O.S. YAUSI, S. ABBAS
Stress analysis by F.E.M. in crack tip and free edge regions in composite material structural elements PDF
A. MANUELLO BERTETTO, G. AUGELLO
Effect of tempering treatment on fracture toughness of 0.4 C steel PDF
B. ERYUREK, E. AKATA
The effect of heat-affected-zone microstructures on fracture toughness of duplex stainless steels PDF
S. ATAMERT, J.E. KING
Investigation of sulfide stress corrosion cracking in low alloy steels PDF
V.I. ASTAFJEV, V.K. EMELIN, T.V. TETJUEVA
The effects of a sulphur-containing environment on high temperature fatigue failure of a nickel based superalloy PDF
E.E. AGHION
Fatigue crack propagation in alumina under cyclic compressive loads PDF
J.M. SABADELL, M. ANGLADA
Mixed mode fracture in compact shear specimens PDF
A. ARSLAN, T.G. HUGHES, B.I.G. BARR
Crack ratio and spall off ratio of reinforced concrete columns PDF
J. OGAWA, M. HOSHI, Y. ABE
Dynamic properties of high strength metallic materials PDF
M.M. AL-MOUSAWI
The transition from plastic flow to combined flow and fracture: the scaling of JR curves PDF
A.G. ATKINS
On non-linear effects in edge-cracked tension specimens PDF
M.A. ASTIZ, C. NAVARRO
Minimum critical length of a microcrack as a construction material criterion PDF
Y. I. RAGOZIN, Y. Y. ANTONOV
Influence of time dependent mechanisms on fatigue crack growth in a single crystal nickel-base superalloy PDF
G. ONOFRIO, S.H. AI, V. LUPINC, G. VIMERCATI
Effect of stress ratio and maximum stress on crack closure PDF
K. ANANDAN, P.K. DASH, K.K. BRAHMA
The effect of solution pH on the initiation and growth of short fatigue cracks PDF
R. AKID, k.J. MILLER
An overview of the NDE flaw acceptance standards based on the R6 assessment PDF
A. ALICINO, E. CAPURRO, A. CORVI, P. PIOVANELLI, S. REALE
Comparison of J Integral behaviour for the tensile panel and pressure vessel PDF
T. ADZIEV, S. SEDMAK, J. GOCEV
Application of probabilistic fracture mechanics theory to calculation of life of gears PDF
B. ABERSEK, S. MIKLUS, J. FLASKER, M. LAKOTA
Determination of the service life of gears with cracks Initiated in tooth root PDF
J. FLASKER, S. PEHAN, B. ABERSEK