General Papers
| Boiler feed water pump shaft life assessment through residual stress measurement | |
| K. Rajanna, C. R. Prasad, G. Jayaraman |
| Cleavage fracture of a high strength steel weld metal | |
| R. K. Hughes, J. C. Ritter |
| Conceptualization of crack closure mechanism maps | |
| V.K. Saxena, V. M. Radhakrishnan |
| Creep - fatigue interaction and life time prediction of AISI 316 stainless steel at 550°C | |
| M. Marchionni, D. Ranucci |
| Design analysis and validation for a bonded composite repair to primary aircraft structure | |
| L. R. F. Rose |
| Failure analysis of adhesively bonded joints | |
| C. H. Wang, L. R. F. Rose |
| Fracture behaviour of a single crystal nickel base superalloy SC16 | |
| A. Rumi, W. Chen, H. Fecht, H. Wever, R. P. Wahi |
| Influence of weld joint mechanical properties on fracture toughness | |
| V. Gliha, I. Rak, N. Gubeljak, M. Kocak |
| Mechanical behaviour and failure criterion of Ti-6Al-4V alloy at room and cryogenic temperatures | |
| G. Laurent, G. Cailletaud, L. Remy |
| Prediction of fatigue interaction from static creep and high frequency fatigue crack growth data | |
| K. Nikbin, J. Radon |
| Tensile behavior of intercritically treated high martensite dual-phase steel | |
| A. Bag, M. Menon, K. K. Ray, E. S. Dwarakadasa |
| Boiler feed water pump shaft life assessment through residual stress measurement | |
| K. Rajanna, C. R. Prasad, G. Jayaraman |
| Cleavage fracture of a high strength steel weld metal | |
| R. K. Hughes, J. C. Ritter |
| Conceptualization of crack closure mechanism maps | |
| V. K. Saxena, V. M. Radhakrishnan |
| Creep - fatigue interaction and life time prediction of AISI 316 stainless steel at 550°C | |
| M. Marchionni, D. Ranucci |
| Design analysis and validation for a bonded composite repair to primary aircraft structure | |
| L. R. F. Rose |
| Failure analysis of adhesively bonded joints | |
| C. H. Wang, L. R. F. Rose |
| Fracture behaviour of a single crystal nickel base superalloy SC16 | |
| A. Rumi, W. Chen, H. Fecht, H. Wever, R. P. Wahi |
| Influence of weld joint mechanical properties on fracture toughness | |
| V. Gliha, I. Rak, N. Gubeljak, M. Kocak |
| Mechanical behaviour and failure criterion of Ti-6Al-4V alloy at room and cryogenic temperatures | |
| G. Laurent, G. Cailletaud, L. Remy |
| Prediction of fatigue interaction from static creep and high frequency fatigue crack growth data | |
| K. Nikbin, J. Radon |
| Tensile behavior of intercritically treated high martensite dual-phase steel | |
| A. Bag, M. Menon, K. K. Ray, E. S. Dwarakadasa |
| Fatigue crack growth studies on lug joints | |
| K. Salish Kumar, B. Dartaguru, T. S. Ramamurlhy, K. N. Raju |
| Fatigue growth behavior of short cracks in alfa/beta SiAlON 1200°C | |
| G.-D. Zhan, M. J. Reece, J.-L. Shi, T.-S. Yen |
| Fatigue of an aluminum alloy under predominantly compressive loadings | |
| N. Ranganathan |
| Fracture and fatigue crack growth behavior of high martensite dual-phase steel | |
| A. Bag, K. K. Ray, K. Aprameyan, E. S. Dwarakadasa, K. V. Sudhakar |
| On the growth of fatigue cracks in advanced ceramics and intermetallics | |
| R. O. Ritchie |
| Three dimensional stress analysis of crack patching | |
| R. J. Callinan, L. R. F. Rose, C. H. Wang |
| Determination of blunting line for ARMCO iron under mixed mode II III loading | |
| M. Srinivas, S. V. Kamat, P. Rama Rao |
| R-curve behaviour of Ai-Li-Cu-Mg alloys | |
| N. Eswara Prasad. M . Ramulu, G. Malakondaiah |
| Status of research aimed at predicting structural integrity | |
| W. G. Reuter |
| Blast-induced fracturing around boreholes and gas-pressurised rapid crack extension | |
| A. Daehnke, N. Kouzniak, H. P. Rossmanith, R. E. Knasmillner |
| Dynamics of brittle fracture | |
| K. Ravi-Chandar |
| Energy dissipation mechanisms at copolymer toughened polymer interfaces | |
| E. Brown, B. Bernard, T.P. Russell |
| Fracture electronics - application of fracture mechanics to microelectronic systems and chip packages | |
| B. Michel, T. Winkler, H. Reichl |
| Influences of interfacial adhesion on thin film mechanical property measurement by nanoindentation | |
| G.M. Pharr, T.Y. Tsui, C.A. Ross |
| Interfacial and near-interfacial fracture in ceramic/metal layered systems | |
| R.O. Ritchie, R.M. Cannon, J.M. McNancy |
| On mixed-mode dynamic crack initiation in brittle solids | |
| D. Rittel, H. Maigre |