General Papers
| Analysis of rolling contact fatigue and fracture | |
| G. T. Hahn, V. Bhargava, H. Yoshimura, C. Rubin |
| Fatigue of composites under spectrum loading | |
| M. M. Ratwani |
| Thresholds for fatigue crack propagation: questions and anomalies | |
| R. O. Ritchie |
| Toughening of ceramics | |
| M. V. Swain, L. R. F. Rose |
| Unified approach for modelling fatigue crack growth and some observations on behaviour under flight simulation loading | |
| K. N. Raju, R. Sunder |
| A new four parameter method for SIF determination | |
| A. F. Ahmed, K. Rajaiah, M.S.C. Bose |
| Application of fracture mechanics in the fracture analysis of wide plates | |
| H.-J. Rosezin, D. Dormagen, W. Hesse, W. Dahl |
| Experimental validation of constitutive relations including ductile fracture damage | |
| G. Rousseller, J. C. De Vaux, G. Mottet |
| Fracture morphology in compacted graphite cast iron | |
| A. Tiziani, E. Ramous, A. Molinari |
| Interaction of a macrocrack with microdamages | |
| V. P. Tamuzs, N. B. Romalis |
| Interrelation among microstructure, crack-tip blunting, and ductile fracture toughness in mild steels | |
| D. Firrao, R. Roberti |
| Near-tip analysis of plane-stress mode-I steady crack growth in linear hardening material with Bauschinger effect | |
| Z. Xiao-ti, Z. Run-fu, H. Keh- chih |
| Stress intensity factor solutions for a cracked bolt | |
| G. G. Reibaldi |
| Stress intensity factors at the tips of cracks emanating from holes with misfit fasteners | |
| P. D. Mangalgiri, T. S. Ramamurthy, B. Dattaguru |
| Tearing instability and the development of voids in a low-alloy steel | |
| C. Q. Zheng, J. C. Radon |
| The ductile fracture toughness of an austenitic-ferritic stainless steel | |
| R. Roberti |
| The steady state propagation of a damaged zone of an elastic brittle solid | |
| H. D. Bui, A. Ehrlacher, C. Renard |
| Width influence on R-curves obtained with thin sheet test-pieces bearing blunt central notches | |
| D. Firrao, R. Ferrario, F. Ricci, R. Roberti |
| A weak beam transmission electron microscopy study of a fatigue crack tip in a 2024 aluminum alloy | |
| K. Rajan, R. L. Hewitt |
| Applicability of energy rate line integral to creep crack growth | |
| V. M. Radhakrishnan |
| Cavity growth during superplastic deformation in 7475 aluminum alloy | |
| M. K. Rao, B. P. Kashyap, A. K. Mukherjee |
| Crack growth in the creep region criteria based on material forces | |
| R. L. Roche |
| Crack propagation studies in austenitic stainless steel in hot corrosive flue gases containing vanadium | |
| S. Ramakrishna Iyer, K. J. L. Iyer, V. M . adhakrishnan |
| Creep crack growth in Nimonic 80A and in a l Cr 0.5Mo steel | |
| H. Riedel, W. Wagner |
| Fatigue crack path in medium-high carbon ferrite-pearlite structures | |
| J. M. Rodriguez Ibabe, J. Gil Sevillano |
| Fractography of fatigue crack growth in low-alloy steels | |
| J. Woodtli-Folprecht, M. Prodan, J. C. Radon |
| Influence of multiple overloads on fatigue crack growth | |
| C. Robin, C. Chehimi, M. Louah, G. Pluvinage, M. L. Schneider, A. Bignonnet |
| Low cycle fatigue propagation of microcracks in two superalloys | |
| M. Reger, F. Rezai Aria, L. Remy |
| North sea oil platforms: failure under random loading | |
| R. Foroughi, J. C. Radon |
| On the influence of the initial DK level on the post overload crack propagation behaviour | |
| N. Ranganathan, J. Petit, J. de Fouquet |
| Prediction of fatigue crack- growth patterns and lives in three-dimensional cracked bodies | |
| J. C. Newman Jr., I. S. Raju |
| Strain and damage in concentration zones at low-cycle high-temperature loading | |
| N. A. Mackhutov, M. M. Gadenin, O. A. Levin, A. N. Romanov |
| The effects of mechanical and environmental variables on fatigue crack propagation in butt-welded joints | |
| S. P. Moghadam, J. C. Radon |
| The influence of grain size on creep rupture properties of type 316 stainless steel | |
| S. L. Mannan, P. Rodriguez |
| The influence of microstructure on stage I fatigue crack growth in a 13pct chromium steel | |
| S. K. Bhambri, P. Rama Rao |
| A method for determining crack velocity stress intensity curves for stress corrosion cracking of GRP | |
| F. R. Jones, J. W. Rock |
| Characterization of failure behavior of advanced composites using off-axis flexural strength tests | |
| R. S. Raghava |
| Effect of environment on low- cycle fatigue behaviour of cast nickel-base superalloy IN738LC | |
| G. Jianting, D. Ranucci, E. Pieco |
| Fatigue crack growth in a glass fibre reinforced plastic | |
| C. R. Wachnicki, J. C. Radon |
| Fracture studies of coconut tree based fibres | |
| K. Sukumaran, S. G. K. Pillai, K. K. Ravikumar, K. G. Satyanarayana |
| Influence of environment on the crack path in a superalloy at low fatigue crack growth rates | |
| J. N. Vincent, L. Remy |
| Interaction of non- coplanar cracks application to rock fracture | |
| H. P. Rossmanith, R. J. Beer, H. N. Linsbauer |
| Measurements of the fracture toughness KIc of concrete | |
| P. Rossi, P. Acker, D. Francois |
| Observations of crack nucleation and growth in polymers using the SEM | |
| V. R. Regel, A. H. Leksovskii |
| On modelling of delamination in laminated plates (an alternative to fracture mechanics approach) | |
| J. N. Reddy, A. Grimaldi, D. Frederick |
| Recent results in dynamic photoelasticity as applied to rock fracture mechanics | |
| H. P. Rossmanith |
| Studies on fracture and strength behaviour of Al-glass and Al-flyash particulate composites | |
| B. N. Keshavaram, K. G. Satyanarayana, B. Majumdar, P. K. Rohatgi, B. Dattaguru |
| The influence of electrothermal treatment on hydrogen embrittlement of AISI 4340 steel | |
| V. L. A. Silveira, G. F. W. Soares, J. L. B. Ribeiro, W.A. Mannheimer |
| Adiabatic shearing and associated cracks in ballistic steel targets | |
| Y. Tirupataiah, V. M. Radhakrishnan, K. R. Raju |
| Criteria for dynamic crack curving and branching | |
| M. Ramulu, A. S. Kobayashi |
| Evaluation of dynamic fracture toughness in a Cr-Mo-V cast steel weld joint | |
| K. Rajanna, S. K. Bhambri, D. R. G. Achar |
| Influence of grain size and strain rate on acoustic emission during deformation and fracture of a type 316 stainless steel - preliminary results | |
| B. Raj, T. Jayakumar, D. K. Bhattacharya, P. Rodriguez |
| Investigation of an aircraft accident by fractographic analysis | |
| R. V. Krishnan, S. Radhakrishnan, A. C. Raghuram, V. Ramachandran |
| Investigation of creep behavior of Ti-alloy by impression test | |
| H. Y. Yu, M. A. Imam, B. B. Rath |
| Magnetic technique for evaluating the fatigue strength of ferromagnetic steels | |
| P. Ruuskanen, P. Kettunen |
| Morphology of static orthotropic isochromatic crack-tip fringe patterns | |
| H. P. Rossmanith, H. N. Linsbauer |
| Quality control for nuclear grade austenitic stainless steels using Charpy impact testing | |
| S. K. Ray, P. R. Sreenivasan, K. G. Samuel, P. Rodriguez |
| Some theoretical and experimental aspects of mixed mode fractures | |
| H. A. Richard |
| Structure-metallurgical approach to design of steels with high crack propagation resistance | |
| O. N. Romaniv, A. N. Tkach, V. N. Siminkovich |
| The application of fracture mechanics methodology to the damage tolerance analysis of the Boeing 757 airplane | |
| S. Rao Varanasi |